The universal 53″ throttle cable solves the problem of non-standard handlebar and carburetor fitment.
The universal throttle cable is also useful for fitment to obscure machines where stock cables are not available.
53″ Barnett throttle cable in a nylon-lined casing is top quality and made in the USA. Comes with cable nipples and ferrules. Requires soldering nipple to cable inner wire.
The universal throttle cable works as any pre-fit cable once correctly measured and sized for correct overall and free-length.
Installed by fitting throttle end of cable into twist-grip, then fitting carburetor end of cable through carburetor top into throttle slide.
Supplied with:
- 53″ Housing
- 46 Ferrule
  Derby hat fitting. Fits at top of Amal carburetor
- 48 Slide Lift Fitting
  Fits at carburetor flat or round slide. Solder fitting.
- 49 Cable Sleeve
  Fits over cable to tighten set screw against.
- 52 Ferrule
  Standard throttle, air, spark ferrule. .220 diameter
- 37-B (Universal) Cable End
  For use on carburetors or throttles
Note: This is a universal throttle cable, use the fitting required for your application. You will have extra fittings!
Reviews
There are no reviews yet.